LiftMate Wiring Guide for Hi-Tide Boat Lift Controller – Safe & Simple Installation
Installing
your LiftMate with a Hi-Tide Boat Lift Controller is simple when done safely
and correctly. Follow this easy guide to complete your wiring setup for smooth
and secure lift operation.
⚠️ Important Safety Warning
The LiftMate
device must only be connected to 5–32VDC or 12–24VAC.
Never connect it to higher voltage sources.
Before wiring, disconnect power by unplugging the lift or switching off
the breaker.
Tools
& Materials Needed
- LiftMate device with wiring
harness
- T-Tap connectors (included with
LiftMate)
- Screwdriver and wire strippers
- Electrical tape
- Hi-Tide receiver wiring diagram
- Multimeter (optional)
Step-by-Step
Wiring Instructions
1.
Turn Off Power
Always disconnect power to ensure safety before wiring.
2.
Locate the Receiver Board
Open the Hi-Tide control box and locate the terminal block labeled Raise
(CH1 NO), Lower (CH2 NO), and Common.
3.
Connect LiftMate Control Wires
o Blue wire → Raise (CH1 NO)
o Purple wire → Lower (CH2 NO)
o Black wire → Common
4.
Connect Power Supply
o Attach the red wire from the
LiftMate power cable to the 24VAC (+) terminal on the receiver board.
o Use the provided T-Tap connector
for a secure connection.
5.
Connect Common & Sensor Wires
o Join the black common wire
from the LiftMate power cord with the white common wire (running from
the transformer to the UP/DOWN switch).
o Use the provided T-Tap connector.
o If your boat lift includes limit switch sensors,
connect their remaining wires to the upper and lower limit switch
terminals as shown in the diagram.
6.
Sensor Configuration
o For correct operation, open the LiftMate
App and enable Flip Sensor Logic for the Storage or Lower
Limit Sensor, depending on your setup.
7.
Final Checks
o Double-check all connections.
o Restore power to the lift.
o Test the LiftMate app to confirm
proper Raise/Lower operation before regular use.
Troubleshooting
Tips
- Device won’t power on: Check red wire connection and
verify voltage (12–24VAC).
- Lift not operating correctly: Ensure blue, purple, and black
wires are connected properly.
- Sensor not reading: Try enabling or disabling “Flip
Sensor Logic” in the app.
- Still stuck? Contact LiftMate support
for expert help.
Support
Contact
📧 support@lift-mate.com
Best
Practices
- Label all wires before
disconnecting.
- Take a photo of your original
wiring for reference.
- Keep connectors sealed and free
from moisture.
- Recheck connections periodically
for wear or corrosion.
LiftMate makes your Hi-Tide boat lift smarter, safer, and easier to control — right from your smartphone.
.png)
Comments
Post a Comment